Á¦Ç°Á¤º¸ >> ¹æ¼Û¤ýÅë½Å >> ¹æ¼ÛÀ½Çâ±â±â  
   ¹«¼±¸¶ÀÌÅ©
¾÷ü¸í   (ÁÖ)¼¼¸í¿¡½º¿¥Áö
¸ðµ¨¸í   UWP-S2
±Ô°Ý¸í   SONY
Á¦Ç°¼³¸í
ÀüÈ­
  02-2047-0220 Æѽº   02-2047-0229
twitter facebook
Á¦¸ñ ¾øÀ½

 

- UWP½Ã¸®Áî´Â ÃÖ´ë 16°³ÀÇ ¹«¼± ¸¶ÀÌÅ©·ÎÆùÀ» µ¿½Ã¿¡ ÀÛµ¿ ½Ãų ¼ö ÀÖ´Ù.
- ÈÞ´ë¿ë ¸¶ÀÌÅ©·ÎÆù°ú ÇÏÇÁ ·¢ »çÀÌÁî Æ©³Ê·Î ±¸¼º.
- PA ½Ã½ºÅÛ¿¡¼­ »ç¿ëÇϱ⿡ ÀûÇÕ.
- ÈÞ´ë¿ë ¸¶ÀÌÅ©·ÎÆù¿¡´Â ¸¶ÀÌÅ©·ÎÆù Ȧ´õ¿Í ½ºÅ©·ç ¾î´ðÅÍ°¡ ÇÔ²² Á¦°ø.
- ÇÏÇÁ ·¢ »çÀÌÁî Æ©³Ê¿¡´Â AC/DC ¾î´ðÅÍ°¡ ÇÔ²² Á¦°ø.

[UTX-H1 »ç¾ç]
- Oscillator : Crystal-controlled PLL synthesizer
- Type of emission : F3E
- Carrier frequencies
   * Receiving frequencies : 740.125MHz~751.875MHz
- RF power output : 10 mW or 5 mW (selectable)
- Antenna : 1/4 ¥ëwave length wire (internal)
- Pilot tone signal : 32 kHz
- Frequency response : 100 Hz to 18 kHz (typical)
- Reference deviation : ±5kHz (-94 dB SPL, 1kHz input)
- Signal-to-noise ratio
   * 60 dB or more (±5kHz deviation at 1 kHz modulation, A-weighted)
- Microphone capsule : Dynamic capsule (uni-directional)
- Audio attenuator : 0 to 21 dB (in 3 dB steps)
- Max. input level : 151 dB SPL (at 21 dB attenuator level)
- Indicators
   * LCD : Operating channel number/frequency, attenuator level,
               RF-output level (High/Low), audio input status, RF-output status,
               transmitte battery status, and accumulated operating time
   * LED : Power status
- Power requirements : DC 3.0 V (two AA-size alkaline (LR6) batteries)
- Battery life : Approx. 6 hours with Sony AA-size alkaline (LR6) batterie at
                    25¡É(77¢µ) at 10mW output
- Dimensions : ¾52 x 240 mm (¾2 1/8 x 9 1/2 inches)
- Mass : Apporx. 300g (10.6 oz) including batteies
- Supplied accessories : Microphone helder (x 1), screw adaptor (x 1)

[URX-R1 »ç¾ç]
- Oscillator : Crystal-controlled PLL synthesizer
- Type of emission : Space diversity
- Receiving frequencies : 740.125MHz~751.875MHz
- Antenna : 1/4 ¥ëwave length wire
- Pilot tone signal : 32 kHz
- RF squlch level : 25 dB¥ì
- Frequency response : 50 Hz to 18 kHz (typical)
- Reference deviation : ±5kHz (at 1kHz modulation)
- Signal-to-noise ratio
   * 60 dB or more (±5kHz deviation at 1 kHz modulation, A-weighted)
- Audio output connector : 1/4-inch phone jack (unbalanced) or ZLR-3-32
                                      type(balanced)
- Audio output level
   * XLR-3-32 : -28 dBm (LINE level) or - 58 dBm (MIC level)
   * 1/4-inch phone jack : -30 dBm
- Monitor put connector : 1/4-inch stereo mini jack (x 1)
- Monitor put level : 5mW (at 16¥Ø)
- Indicators
   * LCD : Operating channel number/frequency, attenuator level,
               RF-output level
   * LED : RF-input status
- Power requirements : DC 9.0 V
- Dimensions (WxHxD) : 212.0 x 44.0 x 209.0 mm